KPI-JCI FT300DF Operation And Service Manual page 208

M
AINTENANCE
T P M
RACK LANT AINTENANCE
4. Use a hammer and a drift to set the bushing and the cog sheave by hitting the bushing on the large side
opposite the split in the bushing. Hit bushing on both sides of the screw. Do not hit close to the outside
of the bushing to avoid damage.
5. Repeat steps working towards the split line.
6. Re-torque the bolts and repeat hitting the bushing until torque no longer turns the screws after
hammering.
7. Install the belt, if removed.
1 Incorrect
2 Correct
3 Incorrect
8. Make sure when the belt is installed that it is positioned and tracks correctly.
P
ROCEDURES
WARNING: Do not operate the plant without a drive guard. Serious injury or death
could occur.
198