Troubleshooting - Panasonic EW3152 Operating Instructions Manual

TROUBLESHOOTING
Remeasure b Pressurization to more than 280mmHg was » Were measurements taken
mark E is performed. according to the proper procedure
and in the correct posture?
displayed.
B/ 3 15:30 Pressure decreased suddenly and the remeasure » Apre
P| mark E appeared. >
> The heart mark «f^ blinked only a few times or > Be sure your arm is properly
not at all, inserted into the main unit,
See p. 13.
If problem continues
Symptom
+ You moved or talked during measurements.
a i MEN odis + Your arm was not inserted properly into the main unit.
po See p.13and 14,
een D> | © Blood pressure varies in response to minute changes in your mental
ee state, such as your reaction to a doctor's presence.
Measurement values are different > e Relax for 4 to 5 minutes and take another measurement. >
with each measurement, See p. 14 and 17.
> + Batteries are installed with the polarities wrong,
No display appears even when the
} See p. 11. >
On/Off Start button is pressed.
o
E
>
5
o
- E 2
LJ
o g
o
o
o
=
D
o
>
x
o
<
If problem continues
When the On/Off Start button is +. Batteries are exhausted,
pressed, the display disappears during | D>
pressurization (7x. mark apears).
+ Since measurements are taken during pressurization, operating
sound may be heard and pressurization rate may change during
pressurization. This is normal and is not a malfunction.
During pressurization, the sound or
pressurization rate changes.
+ Press the ring portion on the outside of the pressure cuff into the
main body.
Pressure cuff comes of
See p. 18.
Take it to the store where it was
purchased for testing and repairs.
Instrumentis broken. >
26