Storing Measurement Values - Panasonic EW3152 Operating Instructions Manual

STORING MEASUREMENT VALUES
This product can separately store 90 measurements
each for two persons.
N After measurement, the CD (E) will light.
Press the M/R
(memory/recall) button
with the number corresponding to
the person for which measurements should be
stored.
Example: Person A: Press (D
Person B: Press (2)
Storing is completed.
e Up to 90 measurement values can be stored.
When the memory is full and additional values
are stored, the oldest value in memory will be
deleted and the new value will be stored.
e If measurements could not be taken properly
(the E mark is shown instead of the blood
pressure value), measurement values cannot be
Number stored.
of stored * However, if the E mark is displayed for only the
data pulse value, data can be stored.
To erase all measured values stored in memory:
1. Recall the measurement value for the person whose data you want to delete by pressing
that person's M/R (memory/recall) button.
2. Press the same M/R (memory/recall) button again, and hold it pressed until the
measurement values disappear (approximately 3 seconds or more).
* |t is not possible to erase single measurement values.
To switch off the blood pressure monitor,
| 9wott press the On/Off Start button.
Start
e |f you forget to switch it off, the blood pressure monitor
will switch off automatically after approximately 5
minutes.
19