Philips 3000 Manual page 10

10 English
4 Close the lid. Place the reservoir back on the base.
Note: Press down firmly to ensure there is no gap between the reservoir
and the base.
5 Insert your preferred nozzle into the handle. Press the nozzle down until
you hear a "click".
6 Press the on/off button on the base station to turn on the product. Select
your desired mode (see 'Modes') and intensity (see 'Intensity Settings').
7 Remove the handle from the base and point the tip of the nozzle into the
sink. Slide the pause switch on the handle to the 'on' (up) position and wait
until the water stream comes out of the tip of the nozzle. Stop the flow of
water by sliding the pause switch to the 'off' (down) position.
Note: This step is for first time use after purchase only.