Table of Contents
Advertisement
Кы
ЕМ-ЗООВ
Ou»
Н. Graphic Equalizer
(Except on ЕМ-10011) Two banks
of linear slide controls independently vary the
frequency response of the Left and Right Program
outputs. There are seven G-EQ controls per channel
on the EM-15011B and nine controls per channel on
the EM-200B and EM-300B. Center detents mark the
"flat" position (no EO effect) for each control.
Aux Pan (Models EM-200B and EM-300B only) These
controls position the Aux 1 and Aux 2 Input signals
Left-to-Right on the stereo program bus.
|
Master Reverb/Echo This control sets the level at
which the returning Reverb/Echo signal (or the
reverb from the built-in spring) is mixed into the
stereo program bus. (The mono signal is applied
equally to the Left and Right program mix buses
and is thus a "center" effects return.) If the Echo
Return jack is used-as an auxiliary monaural line
input, Master Reverb/Echo adjusts the, level of the
"auxiliary" input source.
à
vu
г@
tof
af
if
|
=
N.
— I
CAM
M
N
Headphones Jack This TRS (tip-ring-sleeve) stereo
phone jack can be used with any stereo headphones.
It carries the same signal as the Speaker outputs, but
at lower level, The headphone volume is controlled
by the Master Program faders.
Auxiliary Volume These controls set the level of any
program fed to the mixer via the Left and Right Aux
Input jacks. Following these controls, the aux inputs
are also affected by the Master Program faders.
Master Program Faders (Left and Right) These
controls adjust the lével of corresponding Left and
Right program mixing buses which simultaneously
feed the Speaker, Graphic ЕО, Line, and Headphone
outputs," The Master Program faders DO NOT affect
the mixer's Monitor or Echo outputs.
Master Monitor Faders (1 & 2) These controls adjust
the overall level of the Monitor Outputs..
` *NOTE: In this manual, we use the terms "stereo program bus"
and "Left and Right program mixing buses" interchangeably.
Advertisement
Table of Contents
