Table of Contents
Advertisement
$4115H
Recording
Electric
Control
Room
Monitor
18
S4115H
Studio or
Broadcast Production
The EM-Mixers can be used for broadcast studio
production, or for location work. The input channel
flexibility allows the engineer to use mics, tape machines,
or external phono preamps. The announcer can use the
Monitor 2 (pre-fader) Output for previewing a mono mix,
and the Left and Right Line Outputs for a program feed.
Alternately, the Monitor
2 Output may be used to feed a
mono program to the transmission or recording point,
with the Speaker outputs used as control room and/or
studio monitors.
Maintenance
When operating your EM-Mixer, never cover the air
vents on the top or bottom panel. Constricting the air
flow through these vents may cause overheating and
damage to the mixer.
The use of solvents for cleaning the front panel
may cause discoloration. Dust the panels and control
knobs with a soft cloth; use a damp sponge with a mild
dish detergent if necessary.
Your EM Series II Mixer is an integrally-designed unit.
It requires no regular maintenance, other than common
sense and reasonably careful handling. Should a problem
develop within the Mixer, refer servicing to an authorized
Yamaha M.I. dealer or service center.
If you encounter other problems like no Echo, output
on only one channel, Monitors or Sepaker outputs only
working on one jack, etc.; re-check all input/output
connections, pan controls, and the channel and
master faders. Also, see the troubleshooting chart on
page 20.
Yamaha Electronic Piano
Tape Machine
Advertisement
Table of Contents
