Hub Ip Settings - Multitone EKSHUB Administrator's Manual

PLEASE NOTE: In the event that a Hub configured in NTP server mode does not receive
a response to a request for the current time within 30 seconds, the Hub will continue with
its current time data and send a new request in 24 hours. If the request is rejected by the
NTP server, the Hub will no longer send requests to the NTP server and will display a
Abgelehnt message beside the NTP server address.
Datumsformat
The date format defined in the Hub determines the display format in the following locations:

The LCD display on the Hub itself

The display on Pagers connected to the system
The date can be displayed as either tt/mm/jjjj or mm/tt/jjjj. To apply the desired format,
select the appropriate setting from the Datumsformat drop-down menu and click
BESTÄTIGEN.
PLEASE NOTE: The timestamp logged for each record in the system Event Log, Pager
Log, and Device Status pages are printed in jjjj-mm-tt format. This cannot be changed.
UTC Zeitabstand
The UTC Zetabstand setting can be used to adjust the configured system time according
to global time zones and is intended to offset time data received from an NTP server.
Select an option from the UTC Zeitabstand drop-down menus to adjust the system time by
the configured value and click
Sommerzeit
To apply a Sommerzeit schedule to the Hub system time, select the appropriate region
from the drop-down list. The system time will automatically adjust to accommodate the
time changes on the appropriate date.
Click BESTÄTIGEN to apply.
5.1.2

HUB IP SETTINGS

The primary IP settings of the Hub are configured in the LAN 1 section of the system
settings page.
Hub devices are configured with the default IP address off 192.168.1.2. To change this,
enter a new address into the IP-Adresse fields.
BESTÄTIGEN to apply.
EkoSecure DIN VDE V 0825-1 compliant Hub Administrator Guide
5 Konfiguration menu
Fig. 14 The Hub LAN 1 IP settings
9262-0119 Issue I
23