Table of Contents
Advertisement
MDX-595
TO SERVICE PERSONNEL
1. Critical Components Information.
Components having special characteristics are marked Z
and must be replaced with parts having specifications equal
to those originally installed.
2. Leakage Current Measurement (For 120V Models Only).
When service has been completed, it is imperative to verify
that all exposed conductive surfaces are properly insulated
from supply circuits.
Meter impedance should be equivalent to 1500 ohm shunted
by 0.15µF.
Leakage current must not exceed 0.5mA.
Be sure to test for leakage with the AC plug in both
polarities.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURES
O T H E R T H A N T H O S E S P E C I F I E D
HEREIN MAY RESULT IN HAZARDOUS
RADIATION EXPOSURE.
THE MINI DISC RECORDER SHOULD NOT BE
ADJUSTED OR REPAIRED BY ANYONE EXCEPT
PROPERLY QUALIFIED SERVICE PERSONNEL.
WARNING: CHEMICAL CONTENT NOTICE!
The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and/or
plastic (where applicable) components may also contain traces of chemicals found by the California Health and
Welfare Agency (and possibly other entities) to cause cancer and/or birth defects or other reproductive harm.
DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR
ANY REASON WHATSOEVER!
Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes
or expose eyes to solder/flux vapor!
If you come in contact with solder or components located inside the enclosure of this product, wash your hands
before handling food.
G, B models
G, B models
1
WALL
EQUIPMENT
UNDER TEST
OUTLET
INSULATING
TABLE
Laser Diode Properties
Material:
GaAIAs
Wavelength:
785 nm
Pulse time:
Read mode ...0.8 mW Continuous
Write mode ...max 10 mW 0.5S
AC LEAKAGE
TESTER OR
EQUIVALENT
min cycle 1.5S
Repetition
Advertisement
Table of Contents
