Table of Contents
Advertisement
@REMOVING THE MTS PCB ASS'Y
@ Remove the rear cover.
1. Pull the MAIN PCB Ass'y outward and unsolder the
connections indicated in Fig. 4.
@REMOVING THE PIP UNIT
@ Remove the rear cover.
1. Pull out the main chassis. Take out 3 screws
©O
indicated in Fig..5, pull the unit outward and raise it to
remove.
eSETTING
UP THE
MAIN
CHASSIS
FOR
CHECK & REPAIR
@ Remove the rear cover.
;
1. Stand the set on the PIP unit side as indicated in Fig.
6. Disengage wire clamps and connectors as required.
% During energized checks, use paper or other insulation
to prevent contact between the MAIN PCB Ass'y and
CRT SOCKET PCB Ass'y or other energized compo-
nents.
eWIRE CLAMPING AND CABLE TIES
e Be sure to clamp the wire.
Never remove the cable tie used for tying the wires
together.
;
Should it be inadvertently removed, be sure to tie the
wires with a new cable tie.
<MAIN PCB ASS'Y
AV-27715S.
MTS PCB ASS'Y_-
(No.50577) 25
Advertisement
Table of Contents
