Lithonia Lighting EDGR Installation Instructions page 5

INSTALLATION INSTRUCTIONS for Lithonia Lighting EDGR & EDGRNY Models
OPTIONAL REMODEL BRACKET-MOUNT INSTALLATION INSTRUCTIONS
The unit comes with hardware (placed in a separate pouch) for drywall remodel installation. The pouch
NOTE:
should contain a set of (4) metal brackets, (4) small screws, (4) nuts, (4) long screws, and (4) screw holders.
1. Remove all mounting hanger bars.
2. Slide the screw holders into the holes on the unit's housing as shown in Figure A.
3. Secure the screw holders with the small screws provided (refer to Figures B and C).
4. Position the metal brackets beneath the screw holders and inset the long screws (refer to Figure D). Tighten the screw
until the head reaches the screw holder (refer to Figure E).
CAUTION: DO NOT TIGHTEN THE SCREWS TO THE POINT WHERE THE BRACKETS START TO EXPAND OUTWARD.
5. Cut a hole in the ceiling or wall using the provided template. Turn housing on the side and slide through the hole in the ceiling or wall.
6. Once the housing is inside the ceiling or wall, return back to original position and start tightening the long screws. At this point the
brackets start to bow out (refer to Figure F).
7. Follow steps 4-8 from page 2 to finish.
RECESSED BOX SIDE HANGER BAR-MOUNTING INSTRUCTION
1. Knock-out the slot at the end of recessed box (refer to Figure H).
2. Un-tighten the Wing Nut and remove both of the Hanger Bars and washers (refer to Figure I).
3. Install the Hang Bar to the side of the recessed box and tighten up the Wing Nut with the washer (refer to Figure J).
4. Follow steps 1-8 from the "New Installation" Instructions (page 2).
Figure A
Figure D
Figure G
PAGE: 5 of 5
(Ceiling and Wall Mount)
Figure H
SAVE THESE INSTRUCTIONS!
AND DELIVER TO OWNER AFTER INSTALLATION
Figure B
Figure E
Figure I
Figure C
Figure F
Figure J
Part #EMCSA00808 Rev. E
2020.11.13