Advertisement
1. Application
This technical sheets applies to the outline and characteristics of time of flight sensor
Model No. GP2AP01VT10F
2. Outline
Refer to the drawing page 7.
3. Ratings and characteristics
4. Reliability
Refer to the attached sheet, Page 10.
5. Outgoing inspection
6. Supplement
1) This product is built-in SPAD (single photon avalanche diode).
2) Brominated flame retardants
Specific brominated flame retardants such as the PBB and PBDE are not used in this device at all.
3) This product shall not contain the following materials.
Also, the following materials shall not be used in the production process for this product.
Materials for ODS : CFCs, Halon, Carbon tetrachloride, 1,1,1-Trichloroethane (Methylchloroform)
4) Compliance with each regulation
4.1) The RoHS directive (2011/65/EU)
This product complies with the RoHS directive (2011/65/EU) .
Object substances: mercury, lead, cadmium, hexavalent chromium, polybrominated biphenyls（PBB）
and polybrominated diphenyl ethers（PBDE）
4.2) Content of six substances specified in Management Methods for Control of Pollution Caused by Electronic
Information Products Regulation (Chinese : 电子信息产品污染控制管理办法).
Marking Styles for the Names and Contents of the Hazardous Substances
Category
Time of flight
sensor
This table is prepared in accordance with the provisions of SJ/T 11364.
○：Indicates that said hazardous substance contained in all of the homogeneous materials for this part is
below the limit requirement of GB/T 26572
5) Country of origin : China
6) Product mass : Approx . 0.017g
7) The moisture absorption level of this product is MSL.3.
8) Taping specifications : Refer to the attached sheet, Page 13 to 15.
9) Taping moisture-proof packing: Refer to the attached sheet, Page 16 to 18.
10) Eye Safety Considerations
GP2AP01VT10F contains a laser emitter and corresponding drive circuitry. The laser output is Class 1 laser safety under
all reasonably foreseeable including single faults in compliance with IEC 60825-1:2014. The laser output will remain within
Class 1 limits as long as the Sharp recommended device settings are used and the operating conditions specified in this
datasheet are respected. The laser output power must not be increased by any means and no optics should be used with the
intention of focusing the laser beam.
GP2AP01VT10F
Refer to the attached sheet, Page 8 to 9.
Refer to the attached sheet, Page 11.
Lead
Mercury
(Pb)
(Hg)
○
○
Hazardous Substances
Hexavalent
Cadmium
chromium
(Cd)
6+
(Cr
)
○
○
2 / 18
Polybrominated
Polybrominated
biphenyls
diphenyl ethers
(PBB)
(PBDE)
○
○
Advertisement
