Advertisement
1. Application
This packing specification sheets specify the taping specifications for GP2AP01VT10F.
2. Taping method
2.1.Tape structure and Dimensions (Refer to page 14.)
The tape shall have a structure in which a cover tape is sealed pressed
on the carrier tape of conductive Polycarbonate.
2.2.Reel structure and Dimensions (Refer to page 15.)
The taping reel shall be conductive plastic with its dimensions as shown in
the attached drawing.
2.3.Direction of product insertion (Refer to page 15.)
The sensor direction in carrier tape shall be; the detector of the sensor locates to the feeding
hole side of the carrier tape and the sensor window faces to the top of the pocket of the carrier tape.
2.4.The way to repair taped failure devices
The way to repair taped failure devices cut a bottom of carrier tape with a cutter,
and after replacing to good devices, the cutting portion shall be sealed
with adhesive tape.
3. Adhesiveness of cover tape
The exfoliation force between carrier tape cover tape shall be 0.2N to 1.2N
for the angle from 160 degrees to 180 degrees．
4. Rolling method and quantity
Wind the tape back on the reel so that the cover tape will be outside the tape.
Attach 16cm or more of blank tape to the trailer and 40cm or more of blank tape to the leader
and fix the both ends with adhesive tape.
One reel shall contain 1000pcs. Except for the case that device is removed.
There must not be continuously two or more Stock-Outs.
5. Safety protection during shipping
There shall be no deformation of component or degradation of electrical characteristics
due to shipping.
6. Surface resistivity
Name
Carrier tape
Cover tape
Reel
GP2AP01VT10F
Taping specifications
Ω ／□
Surface resistivity (
)
4
8
1×10
to 1×10
4
7
1×10
to 1×10
9
Less than 1×10
13 / 18
Material
Electroconductive polycarbonate
Poly ethylene terephthalate
Poly phenylene ether
Advertisement
