Advertisement
1
The documents are fed over-lapping. | Dirt on the rubber sheet.
(More than one sheet are fed at a time)
(See page 13)
The document is not fed straight
1. The original guide is not adjusted | 1.
Clean the rubber sheet. (See page 9)
Adjust the original guide along by
along by the original.
the original.
. Dirt on the platen roller.
2. Clean the platen roller.
(See page 9)
3. Adjust the pressure re-positioning
the Contact Image Sensor.
(See page 25)
Clean the platen roller. (See page 13)
3. Pressure for the Contact
Image
Sensor
is not equal in the both
sides.
The exceeding part of the original on
the platen roller is dirty
When
copying
or transmitting the
exceeding
part
of the
original
is
printed as blurred black if less than A4
or letter size of original is used.
When
copying,
white
vertical
line
appears that is not on the original.
. Clean the thermal head.
(See page 13)
2. Replace the thermal head.
(See page 25)
. Adjust the level of the sensor 1.
Confirm the operation of the sensor
1. (See page 13)
2. Completely close the cover.
. There is dirt sticking to the thermal
head.
2. The heating element of the thermal
head is broken.
. The recording paper sensor is not
adjusted properly or out of oper-
ation.
2. The recording paper cover is not
completely closed.
3. The switch for recording
paper
cover is out of operation.
Although the recording paper is set
properly,
"CHECK
PAPER
ROLL"
('PAPIER PRUEFEN') is indicated on
the LCD.
. Replace the switch for the re-
cording paper cover. (See page 45)
Advertisement
