Husqvarna Blastrac EBE 350 Operator's Manual page 22

3. Lift the front part of the product and tilt the product
rearward.
WARNING:
product does not tilt forward.
4. Use a brass drift and a hammer to push out the blast
wheel blades.
CAUTION:
the blast wheel blades. There is a risk
that the blast wheel blades will break.
5. Clean the blast wheel fully to make sure that the
blades and impeller will fit correctly and to prevent
unbalance of the blast wheel.
6. Replace all blades and install the machine in
opposite sequence.
To do a check of the V-belt tension
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
page 18 .
22
Make sure that the
Push at the bottom of
Do not operate the product
To stop the product on
2. Remove the 3 screws, the 6 washers and the V-belt
cover.
3. Examine the V-belt for damages and wear.
4. Push the V-belt with your tumb to examine the
tension. If you can push the V-belts a distance of
10–15 mm (A), the tension is correct.
5. Adjust the v-belt tension if it is necessery. Loosen
the 4 bolts of the motor and put strips below the
motor foot.
6. Replace the V-belt if it is necessary. Refer to
replace the V-belt on page 22 .
7. Install the V-belt cover.
To replace the V-belt
WARNING:
belt cover when the power supply is
disconnected and the motors have fully
stopped.
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
V-belt tension on page 22 .
2. Disconnect the power supply.
A
To
Only remove the V-
Do not operate the product
To do a check of the
2111 - 001 - 21.07.2023