Philips HR2660/00 User Manual page 8

ENGLISH
10
Problem
The safety switch is
triggered and the
appliance suddenly
stopped or suddenly
restarts during the
processing.
During processing,
the appliance stops
working when you
open the lid.
During processing, the
appliance stops. There
is no alarm sound or
flashes.
Small amount of water
is leaking out from the
appliance.
E1 displays on the
screen.
The appliance stops
during processing, E2
displays on the screen,
the indicators are
flashing quickly, and
the alarm sounds.
E4 displays on the
screen.
Cause
The front panel knob is
loose.
Excessive ingredients in
the pasta maker.
For safety reasons, the
appliance always stops
working when the
lid is opened during
processing.
The pasta maker has
overheated due to long
continuous working
time.
Water is added before
the program starts.
The shaping disc is not
attached.
The lid is not in place or
not properly attached.
The mixing paddle may
be blocked by some
foreign objects.
The dough may be too
dry.
The wrong program is
selected.
The appliance
malfunctions.
Solution
Make sure the front panel is securely
assembled.
The maximum amount of flour used
for each batch is 500g. If more than
500g is added, reduce the amount of
flour before next batch.
If you need to resume the previous
operation, close the lid properly, and
press the Start/pause button.
Disconnect from the power source,
and allow the pasta maker to cool
down. To better protect the lifetime of
the appliance, the continuous working
time should be less than 45 minutes.
You can restart using the appliance
after 15 minutes of rest.
Follow the user manual instructions
to add water right after the program
starts.
Attach the disc holder to the main
unit, attach the shaping disc properly
and fix the front panel properly to the
device.
Attach the lid properly.
Disconnect from the power source,
clean the pasta maker, and follow the
user manual again to restart the pasta
making.
1 Switch off and unplug your Pasta
Maker. Plug in and restart the
device.
2 If the appliance is still not working,
contact the service center.