Kwikset 69925-001 Installation Manual

69925-001 Rev 01
Required Tools
Additional Tools
(if needed)
wood block
1
Prepare door and check dimensions
2
Adjust the backset of the latch (if needed)
A
Hold the latch in front of the door hole, with
the latch face flush against the door edge.
B
If the latch holes are centered in the door hole,
no adjustment is required. Proceed to step 3.
If the latch holes are NOT centered, adjust
latch. See "Latch Adjustment" (step 2C).
C
Latch Adjustment (only if needed)
Move the pin to
extend the latch.
3
Install latch
slant of latch bolt faces door frame
Drilling Template
Edge of the door
Do not use harsh chemicals or
solvents to clean your lock.
Mechanical lock
Use a damp cloth to wipe away
any excess dirt or debris.
Parts in the Box
Latch
B
A
Not required for
all applications
Emergency Unlock Tool
(privacy locks only)
E
2-3/8" (60 mm)
or
2-3/4" (70 mm)
2-1/8"
54 mm
Door edge chiseled
A
door frame
C (x2)
Template is only needed if a new hole must be drilled in the door.
Face of the door
Fold
Centerline
2-3/8" (60 mm)
2-3/4" (70 mm)
Backset •
Electronic lock
Use a damp cloth on the lock's exterior to wipe
away any excess dirt or debris. Use a dry cloth
to clean interior components.
Screws Passage
Knobs
C
D
H
Strike
Privacy
Knobs
F
Allen wrench
G
K
*Passage knobs only: Call
Kwikset to order a service kit
for 2-1/4" (57 mm) thick doors.
or
Remove plates.
Install drive-
in collar.
slant of latch bolt faces door frame
wood block
Instructions continue on reverse
Installation Guide
Optional
J
M
or
Optional
L
P
1-3/8"–1-3/4"*
35 mm–44 mm*
1"
25 mm
A
centered
not centered
Door edge NOT
chiseled
A
B
N
Q
door frame