Table of Contents
Advertisement
ELECTRICAL FEEDER CABLE REPLACEMENT
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
•
Remove the screw securing the cover "A" on the rear of the cooker (fig. 3.2).
•
Unscrew cable clamp "D" (fig. 3.3).
•
Connect the wires to the terminal block "B" as shown in the diagram in figure 3.4.
•
Take up any slack in the cable and secure with the cable clamp "D".
•
Replace the cover "A".
NOTE: The earth conductor must be left about 3 cm longer than the others.
The operations must be executed by a qualified technician.
POWER SUPPLY
220-240 V 50 Hz
FEEDER CABLE SPECIFICATIONS
Type "H05VV-F"
3 x 1,5 mm
2
A
Fig. 3.2
2225 W
230 V 50 Hz
230 V
L
PE N
1
Fig. 3.4
Fig. 3.3
(L
)
2
B
D
27
27
Advertisement
Table of Contents
