Download Print this page

Toro Groundsmaster 31252 Installation Instructions Manual

Slope sensor kit

Advertisement

Quick Links

Slope Sensor Kit
Groundsmaster
Model No. 31252
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or missing.
1. 1. Warning—read the Operator's Manual; a fast flashing
light and alarm sounding indicates a steep slope; a slow
flashing light indicates a moderate slope; no light indicates
normal operating conditions.
1. 10 A fuse—Telematics / Slope sensor power
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
4000 Series Rotary Mower
140-2710
10A
139-7838
Register at www.Toro.com.
decal140-2710
decal139-7838
Form No. 3432-357 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *3432-357* A
Printed in the USA

Advertisement

loading

Summary of Contents for Toro Groundsmaster 31252

  • Page 1 139-7838 1. 10 A fuse—Telematics / Slope sensor power © 2020—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3432-357* A 8111 Lyndale Avenue South...
  • Page 2: Installation

    Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required Prepare the machine. Sensor module Bolt Washer Install the kit. Mounting bracket Wire harness Fuse Slope decal Install the decal. Fuse decal –...
  • Page 3 Routing the Wire Harness Remove the 2 bolts and washers that secure the controller cover for the power center to the relay Plug the 90° connector into the bottom of the mount, and remove the cover (Figure sensor module (Figure g211643 Figure 2 1.
  • Page 4 Installing the Decal Assemble the controller cover to the relay mount with the 2 bolts and 2 washers that you removed Install the fuse decal onto the decal located previously (Figure under the controller cover Figure g317370 Figure 5 2. Fuse decal 1.
  • Page 5 Plug the calibration connectors together as Check and ensure your machine software is at shown in Figure revision W or higher. Contact your authorized Toro distributor to update the machine software. Turn the ignition key to the O position, but do not start the engine.
  • Page 6: Operation

    Operation Using the Slope Sensor The light and alarm indicates the severity of the slope: • Red light—normal operating conditions • Slow, flashing red light and Advisory 192 displaying on the screen—moderate slope g317557 Figure 10 Advisory 192 • Fast, flashing red light, audible alarm, and Advisory 193 displaying on the screen—steep slope;...
  • Page 7 Notes:...