Adjusting The Skid(S) - Toro 72907 Operator's Manual

Figure 34
1. Anti-scalp roller
2. Spacer
3. Bushing
Machines with Rear Discharge
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
35 and Figure 36.
Figure 35
1. Flange nut
2. Anti-scalp roller
g029957
4. Flange nut
5. Bolt
Figure
g024242
3. Bushing
4. Bolt
1. Bolt
2. Bushing

Adjusting the Skid(s)

For Machines with Rear Discharge
Mount the skids in the lower position when operating
in height of cuts higher than 64 mm (2-1/2 inches) and
in the higher position when operating in height of cuts
lower than 64 mm (2-1/2 inches).
Note:
When the skids become worn, switch the skid
to the opposite sides of the mower, flipping them
over. This allows you to use the skids longer before
replacing them.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the carriage bolts and nuts from each
skid (Figure 37).
33
Figure 36
3. Anti-scalp roller
4. Flange nut
g024243