Advertisement
Available languages
Available languages
VB-500/A/Bi
1) Disassembly
*Turn off the power switch and lock the casters before
Performing the Replacement.
(1) Remove the two screws at the right and left sides of
the front frame.
Pull out the right or left bottom corner of the front
frame and detach the bottom of the front frame.
Hold the top and the bottom of the frame and lift it
up at an angle to Detach the hooks and Remove to
dismount
the front frame
from
the main
body
frame. (Figure 21)
(2
—
Figure 23
(6) Detach
the sheet from the writing
sheet holder.
(Figure 24)
(2) Remove the nine screws at the bottom of the board.
(Figure 22)
Figure 24
(8) Confirm, by the E6 status indicator, that the white
sheet is stationary. Push the Frame Shift button | >
and left the white sheet completely Wind up on the
right side.
(A noise will be heard if the button is kept pushed
after the white
sheet_is
all wound
up.
Push
the
Frame Shift button
[STOP]
to stop the white sheet
before the noise is produced.)
Turn off the power switch.
Note:
If the noise is not stopped, the white sheet
may
be dislocated
from
the
white
sheet
rail.
When the noise is heard, push the [STOP] button
or turn off the power switch promptly.
Figure 22.
(3) Remove the nine screws at the top of the board.
(4) Pull out the bottom of a board unit. (Figure 23)
Besure that Lower Supports Lock into Position.
(5) Hold the top and the bottom of the board at the
board centre. While lifting the board a little, pull out
the top, keeping the main body and the frame in
parallel.
15
S
N A I r
t Be P e S n
Advertisement
