Setting The Built-In Ait - Setting With The Jumper Pins - NEC Built-In AIT User Manual

Setting the Built-In AIT
You can change the following settings with the jumper pins on the rear of the Built-In AIT.
• SCSI ID (factory-set to "ID4")
• Parity function (factory-set to "Enabled")
Hint
Hint
"With jumper plug" means a status that the jumper plugs are attached to two pins.
"Without jumper plug" means a status that no jumper plug is attached to either pin or it is
attached to one of two pins.
22 Built-in AIT
- Setting with the jumper pins -
"Without jumper plug" means that one
jumper plug is attached to one of the two
pins, or that the jumper plug has been
removed altogether. If you remove the
jumper plug, make sure you store it in a
safe place.
SCSI ID (pin 0 to 3 from right)
Unused (NC)
Parity (PD)