Yamaha CVS-10 User Manual page 15

1. Turn ON the REVERB button.
ене
REVERB
2. To set the Reverb Depth, first press the REVERB
button while you hold down the M./SHIFT button.
|| if ==
M./SHIFT / REVERB
ы /
С / ЕЗ
The currently set Reverb Depth will appear.
REVERB DEPTH
VALUE=24
3. Press the A or V button to change the Reverb
Depth.
REVERB DEPTH
VALUE=15
4. When the desired setting is displayed, press the
M./SHIFT button.
=
M./SHIFT
13
{Additional Information]
M@The Reverb effect cannot be used if the
REVERB button is turned OFF.
[Additional Information]
E The Reverb Depth can be set within a range of
0 (MIN) to 24 (MAX).
For example, the lowest and highest REVERB
buttons on an HS Electone respectively
correspond to Depth 0 and 24 on the CVS-10.
@ To select DEPTH, you must press the DEPTH
button while you hold down the M./SHIFT button.
A button: Increase the depth of re-
verberation.
V button: Reduce the depth of re-
verberation.
{Additional Information]
MB Even after you tum OFF the CVS-10's
POWER switch, this Reverb Depth setting will
remain unchanged.