Related Manuals for Toro BU-003867
Summary of Contents for Toro BU-003867
- Page 1 Form No. 3421-433 Rev A 4-in-1 Bucket TX 1000 Compact Tool Carrier Model No. BU-003867 Model No. BU-003879 Model No. BU-003997 *3421-433* A Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Safety ............... 3 Dealer or Toro Customer Service and have the model General Safety ........... 3 and serial numbers of your product ready. Figure 1 Slope Safety ............ -
Page 3: Safety
Slope Safety Safety • Operate the machine up and down slopes with the heavy end of the machine uphill. Weight DANGER distribution changes with attachments. An empty bucket makes the rear of the machine the heavy There may be buried utility lines in the work end, and a full bucket makes the front of the area. -
Page 4: Attachment Safety
Attachment Safety Before Digging • Wear gloves, eye protection, long pants, To prevent damage and disruption to underground substantial slip-resistant footwear, and hearing pipe and cable networks in your proposed excavation protection during operation or while adjusting or site, contact the Dial Before You Dig service. You repairing the machine. -
Page 5: Safety And Instructional Decals
Safety and Instructional Product Overview Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal100-4648 100-4648 1. Warning; crushing of arm hazard; crushing of leg hazard—keep bystanders away from the machine. -
Page 6: Specifications
Specifications Maximum Material Density at Capacity Note: Specifications and design are subject to change without notice. The density of the materials moved by the bucket varies and, therefore, so does the amount of material 4-in-1 Extra High Volume Bucket that the bucket can carry before reaching the maximum load rating. -
Page 7: Operation
Operation CAUTION Hydraulic couplers, hydraulic lines/valves, The 4-in-1 bucket can be used in 4 different operating and hydraulic fluid may be hot. If you contact modes: hot components, you may be burned. • Bucket • Wear gloves when operating the hydraulic •... -
Page 8: Bucket Operation
Bucket Operation You can draw the jaws together to use this attachment as a standard bucket. You can also open the 4-in-1 bucket jaws to dump the contents into a higher area than a standard bucket can reach. When loading material, always have the bucket level to the ground and move forward into the material to be lifted. -
Page 9: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Lubricate the bucket • Ensure that all fasteners are securely tightened. • Inspect the hydraulic system for leaks and loose fittings. Before each use or daily • Clean the areas around the bucket cylinder and mount plate pivot. •... -
Page 10: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action The bucket does not open or close. 1. The hydraulic coupler(s) are not 1. Ensure that the couplers are correctly completely connected. connected and secured. 2. There is an obstruction in a hydraulic 2. Find and remove the obstruction. hose. - Page 11 Notes:...
- Page 12 All repairs covered by these warranties must be performed by an Authorized Toro Service Dealer using Toro approved replacement parts. Repair by an Authorized Toro Service Dealer is your sole remedy under this warranty.