Advertisement
(4)Pay attention to the following point as a pattern
peeling preventive measure when removing the
connector.
- Make the foot pattern length longer than the
coverlay opening.
In general, at least 0.3 mm.
(5)Foot pattern dimensions indicated in the drawings are
intended to achieve the minimum area on the premise
that the reflow-soldering process is used. For manual
soldering or for ensuring solder reworkability, make
a longer pattern at the terminal tip.
(6)When it is needed to provide pattern wiring and through-hole underneath the
socket, it is possible to use it by designing the pattern as shown below in case
insulation underneath the socket is not assured.
Example of through hole
Panasonic Corporation
industrial.panasonic.com/ac/e/
Operation manual for Narrow-pitch connectors A35UH
- Secure space for applying the soldering
iron tip.
Terminal looseness and unwanted
solder creep are preventable by
applying the soldering iron tip here.
©
- 7 -
Panasonic Corporation 2017
The area where there is a possibility
that the contacts touch.
ACCTF32E 201704
Advertisement
