Advertisement
Compatible cards
The following cards can be used when importing images from a card.
• SD/SDHC/SDXC memory card
• CF (Compact Flash) card*
Inserting a card
• Remove the card slot cover in advance.
• Insert an SD card with its front side facing upward
until it clicks in place.
• Insert a CF card with its front side facing upward
so that the end where tiny holes are aligned goes
inside. Inserting the card in the wrong direction
will damage Connect Station.
Removing a card
• Check that the access lamp is not blinking.
• An SD card will be ejected when you gently push
it in and release it.
• In the case of a CF card, pull it out slowly.
Importing images
• Insert a card into the card slot.
• The access lamp will blink, and the import of
images will start.
• The import is complete when the access lamp
stops blinking and stays lit. Remove the card.
* The CFast card is not supported.
Importing via a wired connection (USB terminal)
Import images by connecting Connect Station to a camera/camcorder with an interface cable (USB
cable). For information on the interface cable, refer to the Camera/Camcorder Instruction Manual.
Compatible cameras/camcorders
Cameras/camcorders from which images can
be imported via a wired connection are Canon
compact digital cameras, digital single-lens reflex
cameras, compact system (mirrorless) cameras,
and digital camcorders released in 2010 or later.
Although cameras/camcorders other than these
may be connected via a wired connection, there
is no guarantee for the import of images to
Connect Station.
Importing images
• Use the interface cable that you use to connect a
camera/camcorder to a computer.
• Connect the USB terminal on Connect Station to
a camera/camcorder, then turn on the camera's/
camcorder's power.
• The access lamp will blink, and the import of
images will start.
• The import is complete when the access
lamp stops blinking and stays lit. Turn off the
camera's/camcorder's power, then disconnect
the cable.
10
SD Card
CF Card
Access lamp (green)
Advertisement
