Advertisement
Advertisement
Table of Contents
Related Manuals for Randy's Inspo+
Summary of Contents for Randy's Inspo+
- Page 1 Concentrate Vaporizer Instruction Manual...
-
Page 2: Specifications
SPECIFICATIONS Battery Capacity: 1000mAh Current: 3A Output Voltage: 2.4V / 2.6V / 2.8V / 3.4V / 3.8V Charging Port: USB-C Resistance: ≥0.8Ω POWER ON/OFF After connection, device will power on, and can be used via Auto-Draw. POWER INDICATOR Press the bottom button to light the LCD screen where you can check real-time battery levels. - Page 3 PREHEATING To adjust voltage, press the button once (a vibration will occur). Voltage default is 3.4V, and if it is changed, the device will remember desired voltage setting, even after the bottom of the device is reconnected. 2.4V Yellow (1 signal bar on display) 2.6V Purple (2 signal bars on display) 2.8V Green (3 signal bars on display) 3.4V Blue (4 signal bars on display)
- Page 4 Discreet enjoyment, wherever you go.
- Page 5 Voltage Mode Indicator Battery Percentage Charging Indicator Preheat Indicator Puff Counter New LCD Display Keep track of battery, voltage, puff count, and more with the new LCD Display.
-
Page 6: Led Light Indicator
COMPATIBILITY Inspo+ fits up to 2 Gram carts, and compatible devices like the included Sand Quartz Atomizer. LED LIGHT INDICATOR When voltage is lower than 3.2V, the LED will flash red for 10 times, will vibrate twice, then enter standby mode. The LCD display will list Power as 0. -
Page 7: Important Info
IMPORTANT INFO Vaping Timeout: Smoking greater than 10 seconds, and LED light will flash 4 times and enter standby mode. Short Circuit Protection/Resistance Overload: LED light will flash Red 3 times. No Cartridge Detected: LED light will flash White 3 times. MORE QUESTIONS? SCAN BELOW... - Page 8 Roll with us on Social Media! @randyspapers LEARN MORE LEARN MORE @randyswired ABOUT INSPO+ ABOUT INSPO+ @randyswired @randyswired @randyswired randys.com Randyʼs offers 2 types of warranties on all of our Electronics! LIMITED WARRANTY (1 YEAR) Covers defects that may be present, such as electrical components.
Need help?
Do you have a question about the Inspo+ and is the answer not in the manual?
Questions and answers
Inspo+ stopped drawing. Plenty of material in 2 month old cartridge. Occasionally I can get a good draw, then ba k to nothing. What do I do?
If your Randy's Inspo+ stopped drawing despite having material in the cartridge, check the following:
1. Ensure Proper Airflow – If too much material is in the atomizer, it may block airflow. Use smaller portions and try again.
2. Check Cartridge Connection – Clean the threads on your cartridge to ensure a clear connection.
3. Look for Errors – If the device blinks red three times, there may be a connection issue. If problems persist, contact support.
This answer is automatically generated
White light flashing indicates no cartridge but have one in
According to the provided information, the white LED light on the Randy's Inspo+ flashes three times when no cartridge is detected. If the white light is flashing even when a cartridge is installed, it may indicate that the device is not properly recognizing the cartridge. This could be due to issues such as improper installation, a faulty connection, or an incompatible cartridge.
This answer is automatically generated