Vaporesso XIRON - Vape Kit Manual

Please read this instruction carefully before use to ensure a perfect experience. If there is any additional requirement about this product, please consult the local agent or contact us through our website: www.vaporesso.com

EXPLODED VIEW

SPECIFICATIONS

USE INSTRUCTIONS

Install or replace the coil

Pull out the pod and then pull out the used coil. Install a new one firmly. Reattach the pod back into place.

Fill the E-liquid

Pull out the silicon plug on top. Fill the e-liquid through the slot. Reattach the silicon plug back into place. If it's your first time filling the e-liquid of this pod, please wait for 5 minutes for the e-liquid to soak into the coil.

Adjust the Airflow

To adjust the airflow volume, please rotate the air-inlet ring on the side of the battery.

System Operating

1. Power on/off: press the power button 5 times in 2s.
   
2. Lock/unlock the Buttons: press the power button 3 times continuously to lock or unlock the "+" button and "-" button.
   
3. Start Vaping: press and hold the power button to start vaping. For your safety, please do not vape for more than 5 seconds at a time.
4. Adjust the Power: press the "+" button or "-" button to adjust the power.
   
5. Flip the Screen: press the power button and "+" button simultaneously to flip the screen 180°.
6. System Setting: press the "+" button and "-" button simultaneously to enter the system setting interface, which includes SMART VW, VW, VV, DEFAULT and EXIT.
   VV: select "VV" and press the power button to enter VV mode.
   
   VW: select "VW" and press the power button to enter VW mode.
   
   SMART VW: select "SMART VW" and press the power button to enter ON/OFF setting.
   
   DEFAULT: select "DEFAULT", "YES" and press the power button to restore the factory setting.
   

Charge the Battery

Connect the device and the standard charger via Type-C cable.

PROTECTIONS

1. Overtime Protection: the device will stop working if you vape for more than 5 seconds at a time, and "OVER TIME" will show on the screen.
   
2. Low Resistance Protection: when an extremely low resistance is detected, the device will stop working and show "LOW ATOMIZER" on the screen.
   
3. High Resistance Protection: when a high resistance is detected, the device will stop working and show "HIGH ATOMIZER" on the screen.
   
4. No-load Protection: when there is no coil detected, the device will stop working and "CHECK ATOMIZER" will show on the screen.
   
5. Short-circuit Protection: when a short-circuit is detected, the device will stop working and "SHORT ATOMIZER" will show on the screen.
   
6. Low Voltage Protection: when the battery voltage is too low to start vaping, the device can not be operated and "LOW BATTERY" will show on the screen.
   
7. Over Discharge Protection: when the battery voltage is extremely low during vaping, the device will stop working and "LOW BATTERY" will show on the screen.
   
8. Over Charge Protection: the device will stop charging when it is fully charged.
9. USB Input Protection: when the USB detects an input voltage exceeding the rated voltage, the device will stop charging.
   

1. Please turn off the device when it is not in use.
2. Do not leave the charging device unattended.
3. Do not drop, throw or abuse your device, which may cause damage.
4. Please use a standard USB output charger with proper charging current and voltage range.
5. Keep away from the water or any flammable gas, liquid.
6. Do not expose the device to direct sunlight, dust, moisture or mechanical shock.
7. Do not expose the device to extreme temperature. (Recommended temperature range: -10~60℃ /14~140 ℉ while using and -10~45℃ /14~113 ℉ while storing).
8. EEE Recycling: The product should not be treated as household waste, instead, it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
9. Battery Recycling: The product battery should not be treated as household waste, instead, it should be handed over to the applicable used battery collection point for recycling.
10. Only have your device repaired by Vaporesso. Do not attempt to repair it by yourself as damage or personal injury may occur.

This refillable electronic cigarette is intended for use with compatible e-liquid, which may contain nicotine. Nicotine is an addictive substance and it is not suitable or recommended to use in following cases:

1. This device is not suitable for:
   • Persons under the legal smoking age.
   • Persons experiencing heart disease, stomach or duodenal ulcers, liver or kidney problems, long-term throat disease or difficult breathing due to bronchitis, emphysema or asthma.
   • Persons with an overactive thyroid gland or experiencing phaeochromocytoma (a tumour of the adrenal gland that can affect blood pressure).
   • Persons taking certain medications like Theophylline, Ropinirole or Clozapine and etc..
2. This device is not recommended for:
   • Non-smokers
   • Pregnant or breastfeeding women
3. You may experience the following results if you use nicotine containing e-liquid with this product. If it happens, please consult a healthcare professional and show them this leaflet if possible:
   • Feeling faint
   • Nausea
   • Dizziness
   • Headache
   • Coughing
   • Irritation of the mouth or throat
   • Stomach discomfort
   • Hiccups
   • Nasal congestion
   • Vomition
   • Chest palpitations/pain or an irregular heart rate

This device should not be used by persons under the legal smoking age.