Viatom Wellue POD-2 - Fingertip Oximeter Manual

Table of Contents

Appearance

warning Note:
It's not a medical device. This device is for Sports and Aviation use only and not intended for medical use.

Appearance

Battery Installation. Insert two AAA size batteries into the battery compartment properly, and note the polarity markings.
Start. Open the clip and put finger inside the cushions of the clip (make sure the finger is in the correct position), and then clip the finger. Wait 2 seconds, the Oximeter will power on automatically and start to measure;
Readings. The screen displays as below:

END. When finger is out, the Oximeter shuts down automatically.
Display Perfusion Index. Press and hold Display Key to display the Perfusion index(PI) value.

The finger should be put into the sensor correctly.
Do not shake the finger and relax during measurement.
Do not put wet finger directly into sensor.
Do not let anything block the emitting light from device, i.e. do not use finger nail polish/paints.
Vigorous exercise and electrosurgical device interference may affect the measuring accuracy.
Nail polish may affect the measuring accuracy, and too long fingernail may cause failure of measurement or inaccurate result.
If the first reading appears with poor waveform, then the reading is unlikely true, the more stable value is expected by waiting for a while.

Power supply	2 x alkaline batteries (AAA)
SpO2 Measurement	Display range: 35%~100%
SpO2 Measurement	Measuring accuracy: ≤ 2% for 70%~100%
Pulse Rate Measurement	Display range: 30~240bpm
Pulse Rate Measurement	Measuring accuracy: ±2bpm or ±2% (whichever is greater)