Bosch MED17.5.2 Manual

Ecu probe with avdi

Manual for using MED17.5.2 Bosch ECU probe with AVDI – Page 1.

1. Description: This probe can be used for programming VAG MED17.5.2 Bosch ECU`s. It fits in most BDM

positioning frames and is fitted with LED`s for accurate alignment on the ECU. The "Boot" resistors and the

ignition feed can be switched. With this adapter, there is no need to solder at all.

A = Serial port connection

C = Power Jack

E = Ignition selection switch:

ON/OFF/K-Line

Since the AVDI requires a permanent connection via a 510 Ohm resistor between the K-Line and 12V, This switch

has no function in the AVDI version of this probe.

SET TO "K-Line" POSITION AT ALL TIMES

F = Connect to flash tool.

Adapter Overview

B = Power Switch ON/OFF

D = DIP Switches for BOOT Resistors ON/OFF

G = Connect to serial port on probe (A)

info@chiptuningshop.co.uk

Table of Contents

Need help?

Do you have a question about the MED17.5.2 and is the answer not in the manual?

Page 1 Manual for using MED17.5.2 Bosch ECU probe with AVDI – Page 1. 1. Description: This probe can be used for programming VAG MED17.5.2 Bosch ECU`s. It fits in most BDM positioning frames and is fitted with LED`s for accurate alignment on the ECU. The “Boot” resistors and the ignition feed can be switched.
Page 2 Manual for using MED17.5.2 Bosch ECU probe with AVDI – Page 2. 2. Handling and Adjustment: IMPORTANT - Make sure that the power switch (B) is in the “OFF” position. The power switch must remain OFF so that the pins are not live, until the probe is correctly aligned and in contact with the corresponding pins on the ECU.
Page 3 Manual for using MED17.5.2 Bosch ECU probe with AVDI – Page 3. The pads marked in red have to make contact with the probe. Technical alterations reserved! Copyright by www.chiptuningshop.co.uk This product should be operated by competent personnel only. Chiptuningshop Ltd do not accept any responsibility...