Advertisement
Once a ll b olts h ave b een i nstalled,
tighten
allnuts using allen wrench and socket
onboth bolts and nuts,
Mounting
Misting
Nozzle Assembly
to
Tractor
The rider cooling system misting assembly is
designed to be installed on the tractor's dash.
Some tractors come equipped with rider cooling
system mounting locations.
If you do not have a dash with the included
mounting locations proceed to STEP 3b.
•
Confirm the installation of all four screws
(A) that hold the power unit (AA) to the
mounting bracket (CC).
WARNING:
Debris that may enter the supply
tubes of the climate control system can cause
undesirable
performance
results.
Use care
completing the remainder of the installation to
ensure optimal cooling effectiveness.
Step
1a (Tractors
w/mounting
locations)
•
Remove dust cap from rider's left mount-
ing location.
A screwdriver may be
needed to pry dust cap from dash.
Open tractor hood and ensure that no
wires or cables are located at the bottom
ofthe
mounting location.
Ifwiresor
cables
are present, temporarily
clear the area by
securing them safely away from mounting
location using a supplied cable tie (J).
Advertisement
