Advertisement
•
Empty water tank completely,
replace
cap, and run system to evacuate all wa-
ter in supply lines.
•
Store misting nozzle assembly by folding
over dash of tractor.
•
Ensure the power switch on the power
unit is in the "OFF" position.
•
Clean debris from venting on rear of
power unit.
•
Clean the power unit thoroughly with mild
soap and water.
PROBLEM
CAUSE
CORRECTION
Pump Not
1 .Switch in OFF Position
1.Toggle Switch to ON Position
Running
2.Tractor Key in OFF Position
2.Tractor Key to ON Position
Unit not Misting
1 .Water tank is empty
1.Fill tank with DRINKING WATER
2.Adjustment
valve closed
2.Open adjustment valve
3.FilI cap not sealed
3.Properly seat fill cap
4.Drain plug not sealed
4.Properly seat drain plug
5.Water filter needs replaced
5.Replace water filter
6.Basket filter missing
6.Install basket filter
Water streaming from
1 .Water in air supply lines
1.Drain tank and run system until
Misting Nozzle
(Tank Overfull)
only air is emitted from nozzle
2.Adjustment
valve setting
2.Close adjustment
valve
3.Air filter needs replaced
3.Replace air filter
Inconsistent Misting
1 .Adjustment valve changing
1.Adjust valve to desired mist den-
)osition
sity and tighten locking nut against
power unit housing
Water Dripping from
1 .Drain plug not seated
1.Properly seat drain plug
Drain Plug
2.Drain plug seal is missing or
2.Replace drain plug seal
damaged
17
Advertisement
