Sealey VS0204.V5 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
Keep this product in good working order and condition, take immediate action to repair or replace damaged parts.
9
Use approved parts only. Unapproved parts may be dangerous and will invalidate the warranty.
9
Keep children and unauthorised persons away from the work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
Ensure the work area has adequate lighting.
9
DO NOT use the kit to perform a task for which it is not designed.
8
DO NOT allow untrained persons to use the kit.
8
DO NOT use when tired or under the influence of drugs, alcohol or intoxicating medication.
8
After use, clean equipment and store in a cool, dry, childproof area.
9
Dispose of waste liquids in accordance with local authority regulations.
9
Always read and comply with the warnings on the brake fluid container.
9
Wear eye protection and keep skin contact to a minimum. If brake fluid enters eyes rinse with plenty of water and seek medical
9
advice. If swallowed seek medical advice immediately.
WARNING! Only use new Brake Fluid, used Brake Fluid or other fluids will contaminate the system and possible brake system
‰
failure may result.
WARNING! DO NOT pollute the environment by allowing uncontrolled discharge of fluids.
‰
WARNING! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.
‰
WARNING! Brake fluid will damage paintwork. Any spillage should be flushed with water immediately.
‰
WARNING! DO NOT allow the fluid capacity in the unit to fall below ½ litre during the bleeding process otherwise air may enter
‰
the system.
2. INTRODUCTION
One-person pressure brake and clutch bleeding system suitable for the professional workshop. Low pressure tank (20-40psi) can be pre-charged
with compressed air, making the unit fully portable. Large reservoir means reduced risk of running the system dry during bleeding process or
complete fluid change. Suitable for use on ABS systems. Features a long delivery hose for operation with a low level ramp, and long reach handle
for easy mobility. Supplied with a range of European, Japanese and US vehicle adaptors. Compatible with DOT 3.0, 4.0, 4.0LV and 5.1 Poly-Glycol
based brake fluids. NOT compatible with DOT 5.0 Silicone based brake fluid.
3. SPECIFICATION
Model No: ............................................................... VS0204.V5
Air consumption ..............................................................4.5cfm
Inlet size ...................................................................... 1/4"BSP
Max. air supply ................................................................. 40psi
© Jack Sealey Limited
INSTRUCTIONS FOR
PNEUMATIC PRESSURE BLEEDER KIT
MODEL NO:
Wear
protective
gloves
Original Language Version
VS0204.V5
Fig.1
VS0204.V5 Issue 2 (2) 16/09/20