Sealey AUTO SERVICE Series Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: plEASE READ ThESE INSTRUCTIONS CAREFUllY. NOTE ThE SAFE OpERATIONAl REQUIREMENTS, WARNINGS, AND
CAUTIONS. USE ThIS pRODUCT CORRECTlY, AND WITh CARE FOR ThE pURpOSE FOR WhICh IT IS INTENDED. FAIlURE TO DO SO
MAY CAUSE DAMAGE AND/OR pERSONAl INJURY AND WIll INVAlIDATE ThE WARRANTY.
1. SAFETY INSTRUCTIONS
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are

adhered to when using tools.
DO NOT use tools if damaged.

Maintain tools in good and clean condition for best and safest performance.

Ensure that a vehicle which has been jacked up is adequately supported with axle stands.

Wear approved eye protection. A full range of personal safety equipment is available from your

Sealey dealer.
Wear suitable clothing to avoid snagging.

DO NOT wear jewellery and tie back long hair.

Account for all tools and parts being used and do not leave any in or near the engine.

2. INTRODUCTION & SpECIFICATION
2.1. Introduction. Time and money
saving kit for replacing damaged
brake calliper threads with a new
threaded insert. Features three
alignment plates for correct
alignment of the insert. Kit includes
7mm hex key, stepped drill, M9 tap
and ten inserts in storage case.
2.2. Specification.
Calliper Insert Thread Size:
M9x1.25mm
Replacement Inserts:
VS0462R (Pack of 10)
Ref. Description
1 Alignment Plate - VAG (Volkwagon Audi Group)
2 Alignment Plate - Vauxhall / Opel
3 Alignment Plate - Ford
4 Drill Bit
5 7mm Hex Key
6 Tap M9 x 1.25mm
7 Threaded Inserts (Replacemnt Inserts - pack of 10)
INSTRUCTIONS FOR:
bRAkE CAllIpER ThREAD
REpAIR kIT
MODEL No:
Original Language Version
VS0462
Part No.
VS0462.01
VS0462.02
VS0462.03
VS0462.07
VS0462.04
VS0462.06
VS0462R
VS0462 Issue: 1 - 14/06/11