Control Lever - Hitachi ZW140-6 Operator's Manual

Control Lever

The lift arm control lever and the bucket control lever are used
to operate the lift arm and/or bucket.
Lift Arm Control Lever (1)
Lever
Position
Float:
C The lift arm free falls and can be moved as
loads are applied.
B Lift Arm Lower
Hold:
N The lift arm is stopped and held in that
position.
A Lift Arm Raise
Detent:
F
The lift arm is held in the raise position.
Bucket Control Lever (2)
Lever
Position
Bucket Dump:
E The bucket is tilted forward to dump the
bucket load.
Hold:
N The bucket is stopped and held in that
position.
Bucket Tilt:
D The bucket is tilted back, taking the
transportation position.
Detent:
When the bucket control lever is moved from
G the bucket dump position to the bucket
tilt position, the bucket control lever is
maintained in this position.
f
NOTE:
 Further pull lift arm control lever (1) from "Raise" position
(A), the lever is held in position (F) until the lift arm moves
to the position set at the height kickout. When the lift
arm moves to the preset position, lift arm control lever (1)
automatically moves to "Neutral" (N) position.
 Further turn bucket control lever (2) from "Tilt" position (D)
after bucket dump operation; the lever is held in position
(G) until the bucket moves to the position preset by the
bucket auto leveler. When the bucket moves to the preset
position, bucket control lever (2) automatically moves to
"Neutral" (N) position.
OPERATOR'S STATION
Lift Arm Operation
Bucket Operation
E
2
N
D
G
E
N
D
1-68
C
B
1
N
A
F
MNEC-03-003
C
B
N
A
M4GB-01-072
M4GB-01-073