Precautions; Installation Precautions; Prestart Precautions; Table 3 Ups-Battery Cabinet Compatability Chart - Toshiba 1600XPi Series Installation And Operation Manual

2.0

Precautions

2.1

Installation Precautions

1) Install the unit in a well ventilated location; allow at least 10 cm (4 inches) on
all sides for air ventilation and maintenance.
2) Install the unit in a stable, level, and upright position, which is free of vibration.
3) Install the unit where the ambient temperature is within the correct operating
range.
4) Do not install the Battery System in a location that is subject to high humidity.
5) Do not install the unit at sites that are exposed to direct sunlight.
6) Do not install the Battery System in areas which are subject to high levels of
contamination by airborne dust, metal particles, or flammable gases.
7) Avoid installation near sources of electrical noise. Always make sure that the
unit ground is intact to prevent electrical shock and to help reduce electrical
noise.
8) Do not install where water or any foreign objects/substances may get inside
the Battery System.
2.2

Prestart Precautions

1) Before connecting the Battery System to the UPS verify that the two are compatible by comparing them
to the following chart.
UPS Model Number
H3BG2L080C61T
H3BG2L100C61T
H3BG2L140C61T
H3BG2L180C61T
H3BG2L220C61T
WARNING
2) Before connecting the Battery System to the UPS; switch the ON/OFF switch MCCB2, located on the
rear panel of the battery system to the OFF position. (See Sections 4 & 5)
6

Table 3 UPS-Battery Cabinet Compatability Chart

Battery Cabinet Model Number
DO NOT attempt to connect if the Model numbers do
not match the above chart. This will result in damage
to the UPS, the Battery System, or both. Call your
Toshiba representative if you should have any
questions.
1600XPi Series Battery Cabinet Installation and Operation Manual 64024-006
H3B-BC-1825
Battery Voltage
288VDC