Table of Contents
Advertisement
Advanced Configuration
When you select "Advanced Configuration" and press the Enter key, the display changes as shown
below:
The following table provides information on options and their functions.
Option
Reset SCSI Bus at IC
Initialization
Display <Ctrl><Alt> Message
During BIOS Initialization
Extended Int 13 Transfer for
DOS Drivers > 1 Gbyte
Post Display Mode
SCSI Controller Int 13
Support
Domain Validation
Support Removable Disks
under Int 13 as Fixed Disks
BIOS Support for Bootable
CD-ROM
Parameter
[Enabled]
Disabled
[Enabled]
Disabled
[Enabled]
Disabled
[Verbose]
Silent
Diagnostic
[Enabled]
Disabled: NOT Scan
Disabled: scan bus
[Enabled]
Disabled
Boot Only
All Disks
[Disabled]
[Enabled]
Disabled
System Configuration 4-35
Description
Set "Enabled."
Set "Enabled."
Set "Enabled."
Do not change the settings unless it is
necessary.
Select whether or not to enable SCSI BIOS.
Select "Enabled" except
when starting up the OS from a hard
disk drive other than those connected to
the SCSI controller (it is OK if no hard
disk drive is connected to controller
other than SCSI controller).
when reserving a space in the extended
ROM space. In this case, you can
disable the BIOS of a SCSI controller to
which no hard disk drive is connected.
Set "Enabled."
Options controlled by removable media are
supported by AIC-79xx BIOS.
Set "Enabled."
[
]: Factory-set
Advertisement
Table of Contents
Troubleshooting
