Table of Contents
Advertisement
WARNING: To reduce the risk of fire or electrical shock, do not expose this apparatus to rain or moisture.
WARNING: No naked flame sources – such as lighted candles – should be placed on the product.
CAUTION: To be installed by instructed, or skilled, persons only.
WARNING: This product is intended to be operated ONLY from the voltages listed on the back panel or the
recommended, or included power supply of the product. Operation from other voltages other than those
indicated may cause irreversible damage to the product and void the product's warranty. The use of AC Plug
Adapters is cautioned because it can allow the product to be plugged into voltages in which the product was
not designed to operate. If you are unsure of the correct operational voltage, please contact your local
distributor and/or retailer. If the product is equipped with a detachable power cord, use only the type
provided, or specified, by the manufacturer or your local distributor.
WARNING: Do Not Open! Risk of Electrical Shock. Voltages in this equipment are hazardous to life. No user-serviceable
parts inside. Refer all servicing to qualified service personnel.
Place the equipment near a main power supply outlet and make sure that you can easily access the power breaker
switch.
CAUTION: This product contains batteries that are covered under the 2006/66/EC European Directive, which
cannot be disposed of with normal household waste. Please dispose of any used batteries properly, following
any local regulations. Do not incinerate.
WARNING: 45°C (113 °F) is maximum ambient operating temperature. Avoid exposure to extreme heat or cold.
RACK MOUNTING:
A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of
the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the
equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe
operation of the equipment is not compromised.
C) Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved
due to uneven mechanical loading.
D) Circuit Overloading - Consideration should be given to the connection of the equipment to the supply circuit and the
effect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of
equipment nameplate ratings should be used when addressing this concern.
E) Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be
given to supply connections other than direct connections to the branch circuit (e.g. use of power strips)."
pg. 4
Advertisement
Table of Contents
