Philips 9000 Series Manual page 24

20
English
heads immediately. Always replace the shaving heads with original
Philips shaving heads (see 'Ordering accessories').
Replacement reminder
The replacement reminder indicates that the shaving heads need to
be replaced.The shaving unit symbol lights up continuously, the
arrows flash white and you hear a beep when you switch off the
shaver (Fig. 61).
1 Switch off the appliance.
2 Pull the shaving head holder off the bottom part of the shaving
unit (Fig. 51).
3 Place the retaining ring holder on the retaining ring (1), turn it
anticlockwise (2) and lift it off the shaving head (3).
Remove the retaining ring from the retaining ring holder and
repeat this process for the other retaining rings.
4 Remove the shaving heads from the shaving head holder (Fig. 63).
Throw away the used shaving heads immediately to avoid mixing
them with the new shaving heads.
5 Place the shaving heads in the shaving head holder (Fig. 64).
Note: Make sure the notches on both sides of the shaving heads fit
exactly onto the projections in the shaving head holder.
6 Place the retaining ring holder on the retaining ring (1), place it on
the shaving head (2) and turn it clockwise (3) to reattach the
retaining ring (Fig. 65). Repeat this process for the other retaining
rings.
- Each retaining ring has two recesses that fit exactly into the
projections of the shaving head holder. Turn the ring clockwise
until your hear a click to indicate that the ring is fixed (Fig. 66).
Note: Hold the shaving head holder in your hand when you
reinsert the shaving heads and reattach the retaining rings (Fig. 67).
Do not place the shaving head holder on a surface when you do
this, as this may cause damage.
7 Attach the shaving head holder to the bottom part of the shaving
unit ('click') (Fig. 54).