Sharp VN-EZ1U Operation Manual page 38

Symptom
Cannot play back
Bad picture quality
No sounds during the
Movie playback mode.
Cannot delete images.
Cannot format the
SmartMedia card.
Note:
• The Digital Recorder is equipped with a microprocessor. Its performance could be adversely affected by external electrical noise or
interference. If this should happen, turn off the power and disconnect the Digital Recorder from any power sources. Then reconnect
the power sources to resume operation.
Possible cause
• The lens body mark not aligned with
PLAY .
• The Mode (MOVIE/STILL) select switch not
set securely.
• Dead batteries.
• The SmartMedia card not loaded properly,
or no card loaded.
• Occurs when recorded in the LP (Movie
Recording) or NORMAL (Still Recording)
mode which tends to lower quality to record
longer movie or larger number of still
images.
• The volume set in too low.
• The write-protect seal attached to the
SmartMedia card.
• The images delete-protected.
• The write-protect seal attached to the
SmartMedia card.
Suggestion
• Rotate the lens body to align with PLAY .
• Securely set the Mode select switch (page 22).
• Replace the batteries with new ones or fully charged
rechargeable batteries (page 14).
• Correctly load the SmartMedia card (page 17).
• Change the resolution setting as you desired (see
pages 45 and 46).
• Press ' on the operation button to turn the volume
up.
• Remove the write-protect seal (page 5).
• Unprotect the desired images (page 38).
• Remove the write-protect seal (page 5).
References
72