Names Of Each Part And Connections; Basic Connections - Sanyo DSR-2016 Instruction Manual

Names of each part and connections

Rear panel

Basic connections

• Do not turn this unit on before all the connections are complete. Read the instruction manual of each unit carefully.
• Make sure each unit is connected properly as faulty connection may result in the unit emitting smoke and/or being damaged.
• Feed additional units with the same power source. Stored data may be lost.
(Sold separately)
2
3
4
Video monitor Video monitor
(Sold (Sold
separately) separately)
1 Video input terminal (VIDEO IN/LOOP OUT: CH1 -
CH16)
2 Video output terminal (S-VIDEO)
3 Monitor 2 video output terminal (MON2)
4 Video output terminal (MAIN)
5 Audio input/output terminal (AUDIO IN: CH1 - CH4/
OUT)
6 VGA (Video Graphics Array) output terminal
Connects to the PC VGA monitor.
7 External sensor terminal (ALARM IN: CH1 - CH16)
8 Network terminal (LAN: P5)
9 RS-232C terminal (RS-232C)
For maintenance purposes.
F RS-485 control terminal (RS-485/422: P14)
Camera
1
5 6 7 8
Speaker with
built-in amplifier
(Sold separately)
9 F G H
MENU
AUTO MODE POWER
Monitor
(Sold
separately)
G System changeover switch (SWITCH)
TERMINATE: RS-485 termination switch (P11)
RSV: For maintenance purposes.
VGA: Monitor selection switch (P9)
PAL: Television mode (PAL/NTSC) switching switch (P9)
H Alarm output terminal (ALARM OUT: CH1 - CH4)
I Cooling fan (P1)
J Power switching switch (115V/230V)
Switch according to the voltage used in the region where
this unit is installed.
K Power socket
This equipment is indoor use and all the ethernet
wiring are limited to inside of the building.
I J K
4