Table of Contents
Advertisement
HEADLIGHT BEAM ADJUSTMENT
A
Switch A is used to adjust the height of
the headlight beams according to the
load.
With the dipped beam headlights lit,
press or lift switch A as many times
as is necessary to select the required
position on the instrument panel. The
position selected is displayed on the
instrument panel for approximately
30 seconds.
Note: depending on the vehicle, at
each engine start-up the selected po-
sition may be displayed on the instru-
ment panel for approximately 30 sec-
onds.
1.106
Driver alone or with front passenger
All seats occupied
Driver with passengers and luggage
(or load) reaching the maximum
permissible all-up weight
Driver without passengers and luggage
(or load) reaching the maximum
permissible all-up weight
The table below gives some examples. In all cases, adjust control A accord-
ing to the vehicle load so that the road can be seen and other drivers are not
dazzled.
Examples of positions for
adjusting
control A according to the load
0
2
3
4
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Clio and is the answer not in the manual?
Questions and answers
How do I put the new Renault Clio into reverse
To engage reverse gear in a Renault Clio, press the clutch pedal fully, then push the gear lever to the right and downwards.
This answer is automatically generated
Dashboard setting
The dashboard settings for a Renault Clio include:
- Language
- Unit
- Style
- Colour
These can be adjusted through the “Settings” menu under the “DASHBOARD” tab.
This answer is automatically generated