Husqvarna Rider 13C Workshop Manual page 58

Combi 94, Combi 103
WARNING!
Use gloves and protective
eyewear when working with the
cutting unit.
You can recognise these cutting units by the fact
that the collar on the bearing housing is located
on the underside of the cutting unit's cover.
1. Remove the cutting unit's upper cover, see
"Belt Replacement: the Combi 94, 103, 112" .
2. Loosen the spring (1) that tensions the V-belt
and pull the belt off.
3. Loosen the screw that holds the belt pulley (2)
a few turns. Lock the blade with a wooden
block or hold the belt pulley in place, with an
oil filter wrench, for example.
4. Remove the nuts, which hold the bearing
housing in position, from the top of the cover.
Make sure that the unit is positioned with the
belt pulley against the unit's cover.
5. Place a wooden block under the unit cover so
that the blade is free from the supporting
surface. Knock on the screws to remove the
belt pulley. Do not knock hard enough to
deform the cover. If the belt pulley is stuck,
heat it with a hot air gun. Try not to use a
puller as it can deform the belt pulley. Do not
lose the key that sits between the pulley and
the shaft.
56
– English
Belt adjuster spring and belt pulley
Locking the blades
Bearing housing nuts
Knock the underside of the cover with a wooden block
Reparation instructions