Reparation instructions
5
Remove the fuel line hose clamp from the fuel
pump and pull the fuel line downwards.
Tie the hose higher than the fuel tank level.
6
Release the exhaust pipe clamps, and then
remove the exhaust pipe.
7
Clamp together the wire holder under the engine
pulley with a pair of flat pliers and pull the wire
holder downwards.
24
– English
8
506 89 92-01
Insert tool no. 506 79 06-01 into the centre of the
engine pulley. Unscrew and remove the socket
head cap screw which holds the pulley and the
engine axle together. Use tool no. 506 89 92-01
as a holder-on. Remove the pulley from the
engine axle.
9
Remove the engine attachments, two on each
side of the engine, and remove the engine from
the mower.
Watch where the battery's negative cable is
connected. Disconnect it from the engine if
necessary.
Lift the engine out of the mower, take care of the
key and spacer tube, located on the engine shaft.
506 79 06-01