Table of Contents
Advertisement
Installation
A faucet with a ¾" male thread must be
provided on site. If this type of faucet is
not available, only a qualified installer
may connect the dishwasher to the
drinking water supply.
A backflow preventer is not required.
The appliance meets the requirements
of the applicable DIN standards.
The water connection pressure needs
to be between 7.25 and 145 psi (50 and
1,000 kPa). If the water connection
pressure is too high, a pressure reduc-
ing valve must be installed.
Risk of damage from leaking wa-
ter.
The connection point is subject to
water pressure. Water leaking from it
can cause damage.
You should therefore open the faucet
slowly and check for leaks. Correct
the position of the seal and screw
thread if appropriate.
74
Risk of damage from leaking wa-
ter.
The water inlet hose is under water
pressure.
The water inlet hose must not be
shortened or damaged in any way.
Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be oper-
ated when it is connected to a fully
vented plumbing system.
Advertisement
Table of Contents
