Husqvarna HG 125 VS Original Instructions Manual page 16

Sanding Assembly
tool operations. Do not discard guard when
not in use. Always reinstall wheel guard when
converting back to grinding operations.
To install backing pad and sanding disc (Fig.
10):
1. Unplug tool from power source.
2. Place the rubber backing pad onto the
spindle shaft.
3. Center the sanding disc on top of the
backing pad.
4. Insert the lock nut through the disc and
thread onto spindle.
5. Tighten lock nut with supplied lock nut
wrench while holding spindle lock.
TO REMOVE: Reverse procedure.
Wire Cup Brush Assembly
tool operations. Do not discard guard
when not in use. Always reinstall wheel
guard when converting back to grinding
operations.
Do not use a knotted wire cup brush with
this tool. This tool does not have a guard
for knotted wire cup brushes.
To install wire cup brush (Fig. 11):
1. Unplug tool from power source.
2. Thread wire cup brush onto spindle until
secure. Be sure to seat cup brush against
shoulder before turning tool "ON".
TO REMOVE: Reverse procedure.
Assembly Instructions
A type 27 wheel guard
may not be used for all
A type 27 wheel guard
may not be used for all
FIG. 10
SPINDLE
BACKING
PAD
FIG. 11
SPINDLE
WIRE CUP
BRUSH
-16-
SANDING
DISC
LOCK NUT