Table of Contents
Advertisement
2.5 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. While keeping the release button
pressed, tilt the stand and slide it
out.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.
Note
Please purchase the appropriate wall
mount; otherwise the distance between
the back-plug-in signal cable and the wall
would be too short.
* Display design may differ from those
illustrated in this manual.
Warning
•
To avoid potential creen damage,
such as panel peeling, ensure that the
monitor does not tilt downward by
more than -5 degrees.
•
Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
14
100mm
100mm
0°
-5°
90°
Advertisement
Table of Contents
