Table of Contents
Advertisement
Using the Fuel-Shutoff
Valve
The fuel-shutoff valve is located under the seat. Move
the seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance,
and storage.
Ensure that the fuel-shutoff valve is open when
starting the engine.
Figure 33
1. O
position
N
g008948
2. O
position
FF
Using the
Drive-Wheel-Release
Valves
WARNING
Hands may become entangled in the rotating
drive components below the engine deck,
which could result in serious injury.
Shut off the engine, remove the key, and allow
all moving parts to stop before accessing the
drive-wheel-release valves.
WARNING
The engine and hydraulic-drive units can
become very hot. Touching a hot engine or
hydraulic-drive units can cause severe burns.
Allow the engine and hydraulic-drive units
to cool completely before accessing the
drive-wheel-release valves.
WARNING
The machine could unintentionally move
while the release-valve levers are vertical and
injure you or bystanders.
Rotate the release-valve levers horizontally
after moving the machine.
The drive-wheel-release valves are located in the
back of each hydraulic-drive unit, under the seat.
Note:
Make sure that the release valves are in the
fully horizontal position when operating the machine;
otherwise, severe damage to the hydraulic system
can occur.
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Rotate the release-valve levers vertically to push
the machine
(Figure
Note:
This allows hydraulic fluid to bypass the
pump, enabling the wheels to turn.
4.
Disengage the parking brake before pushing
the machine.
32
34).
Advertisement
Table of Contents
