Panasonic AccuPulse QP Low Noise Series Operating Instructions Manual page 28

Federal Communications Commission Interference Statement
EN
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assume continued compliance, install and use in accordance with provided
instructions. Use only the battery pack specified in the instructions. Any changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate
this equipment.
[EYFLF1RA, EYFLF1RC, EYFLF1RP, EYFLF2RA, EYFLF2RC, EYFLF2RP]
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept
any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Remote control (not included with shipment)
Model
Battery voltage
Dimensions
Weight (with battery)
Radio Information
Model
Indoor/Urban Range
Outdoor RF line-of-sight range
Transmit Power
Assembly Qualifier Sensitivity
FCC ID: MCQ-XBS2C
54 mm (2-1/8") × 86 mm (3-3/8") × 10 mm (13/32")
EYFLF1RA, EYFLF1RC, EYFLF1RP, EYFLF2RA,
IC: 1846A-XBS2C
EYFA31
3 V DC
Approximately 30 g (0.06 lbs)
EYFLF2RC, EYFLF2RP
200 ft./ 60 m
4000 ft./1200 m
3.1 mW (+5 dBm)
-100 dBm (1% packet error)
‒ 28 ‒