Page 2
MEW01961 DATE OF ISSUE: 2016-01-11 REV: DATE OF REVISION: 2021-01-25 Panasonic Fire & Security Europe AB Jungmansgatan 12 SE-211 11 Malmö Sweden Tel: +46 (0)40 697 70 00 Internet: www.panasonic-fire-security.com TECHNICAL DESCRIPTION 4318 • DOCUMENT NUMBER: MEW01961 • REVISION: 2...
1. INTRODUCTION INTRODUCTION This document describes the combination heat detector, type number 4318. The document contains information about the product and instructions on how to mount and connect it. ABBREVIATIONS c.i.e Control and indicating equipment Light Emitting Diode TECHNICAL DESCRIPTION 4318 • DOCUMENT NUMBER: MEW01961 • REVISION: 2...
The detector's LED and a connected external LED will be lit until the detector is reset via the c.i.e. 3.1.2 EXTERNAL LED One External Indicator (LED) can be connected to the screw terminals E+ and E-: TECHNICAL DESCRIPTION 4318 • DOCUMENT NUMBER: MEW01961 • REVISION: 2...
The detector is plugged in a base. Place the detector in the base with the detector's "Mark" in the same position as the "Mark" on the base and turn the detector clockwise. TECHNICAL DESCRIPTION 4318 • DOCUMENT NUMBER: MEW01961 • REVISION: 2...
For information about how to set a zone in test mode, see Planning Instructions or Operating Instructions. It is possible to use test equipment for testing, for example “SOLO” or “Testfire”. TECHNICAL DESCRIPTION 4318 • DOCUMENT NUMBER: MEW01961 • REVISION: 2...
Ingress protection rating IP 51 Size: Ø x H 102 x 39 mm Weight 54 g Available colours 4318 Grey (N8, Munsell colour code) 4318W White (10Y9/0.5, Munsell colour code) TECHNICAL DESCRIPTION 4318 • DOCUMENT NUMBER: MEW01961 • REVISION: 2...