Table of Contents
Advertisement
Installation
60
Water connection
For compliance to The Water Supply (Water Fittings) Regulations
1999, please fit the double check valves included in the scope of
supply to the on-site water supply for every water inlet hose used.
The double check valves prevent water from the inlet hoses flowing
back into the on-site drinking water supply.
Non-return valves are included in the scope of supply.
The flow pressure must be a minimum of 100 kPa and must not ex-
ceed 1000 kPa. If the flow pressure is higher than 1000 kPa, a pres-
sure reducing valve must be used.
The machine must be connected to the water supply using the inlet
hoses included in the scope of supply.
The connection points are subject to water supply pressure.
Turn on the stopcock slowly and check for leaks. Correct the posi-
tion of the seal and screw thread if appropriate.
The enclosed double non-return valves must be installed on the stop-
cock in every water inlet.
Advertisement
Table of Contents
